Stove or brander useful for welding and pipe disconnect. In addition to weld or disconnect, brander can also be used to close the pipe after filling coolant. Brander there are two types, namely LPG fuel and oxygen. Materials to be welded using lead, silver, or brass. To obtain maximum heat, better use of LPG-fueled stoves.
Mememperbaiki electronic soldering required for cooling the engine. This tool works for soldering pipes are leaking or in connection job. Electrical solder used here is not the same as that used by the radio. Solder the required strength above 250 volts so hard to melt lead.
If a small leak occurs in pipes by flowing pressure cold gas soldering should be done to save costs. If a leak in the pipes by flowing hot air, and should be replaced only. Consider the following electrical solder!
The workmanship soldering, soldered pipe surface should be cleaned of dirt, so that tin can stick. Before soldered must be cleaned and then given a paste.
E. EQUIPMENT TESTPEN
Testpen is a tool to determine the flow of AC voltage and also used for a screwdriver. The shape resembles a screwdriver, but on the inside of the stem has a kind of light that can be used to test the flow of electricity. If there is no electricity, the lights are on. At the end of the stem there is a bolt that is associated with the polar lights. While other poles associated with the screwdriver pencolok stalk. At the time of the current test, the rod screwdriver handle with the index finger touching on the bolt that is on top of the trunk. Next, stick the tip of a screwdriver on the supposed flow of electricity. If there is flow, the screwdriver will light.
F. A set SCREWDRIVER FULL (ONE SET)
Figure 4 Various Screwdriver
The screwdriver must be prepared before doing repair work and check the engine coolant. Screwdriver serves to unlock the bolts (screw-screw) which become binding on any other part. Screwdriver should be prepared a variety of sizes, because the bolts are mounted in the engine coolant also varied. Some are large and some are small. Therefore, screwdriver prepared a set of screwdrivers ranging from the smallest to the largest. And in the form of a flat screwdriver (-) and the flower shape (+). Consider the following set of images screwdriver!
Using engine coolant manifold. To remove and install, may not be fit by using a screwdriver. For us we need a wrench. Therefore, a set of keys to fit all sizes should be prepared anyway.
DENTAL MIRROR (DENTAL mirror)
Dental mirror is used to examine the sections of pipe, the inside of which there is a suspected leak. If there is a leak has been confirmed, then the part that should be marked, in order to facilitate the searching and soldering. If not marked feared would not be found again. Thus will add jobs again. Dental mirror is usually equipped with a battery light. This will help facilitate the search for parts of a burst pipe in the dark.
PUMP Vacuum
Vacuum pump mounted on the pipe so that the pipe in the engine coolant into a vacuum. This is done before the engine cooler filled freon gas (cooling agent). Small-type vacuum pump is a compressor hermatic, while great to wear a separate dynamo.
No comments:
Post a Comment